SPECIFICATION SHEET
Z6-6 (2P) – Surge Stopper
United States Navy Shipboard
Surge and Noise Suppressor
Complies with CID #A-A-50622
MIL-STD-1399, MIL-STD-16400, MIL-STD-454
General Specifications: Surge Suppression Specifications:
Model # Z6 Series Protection Modes: H – N, H – G
Dual pole circuit breaker with built-in lighted N – G
Power on/off switch (provides simultaneous
Over-current protection on both sides of the line) Maximum Surge: 35K Volts, 35K Amps
Complete multiple stage hybrid surge and 20,000,000 watts
Noise filtering network (8 x 20 ms surge pulse)
Dual thermal fuses on Hot and Neutral Joule Rating: 1,000 Joules
6 Outlets Response Time: Instantaneous
6 foot 14/3 SJEOW heavy duty power cord
Durable, lightweight aluminum case with Voltage Clamping Beginning clamping
Baked on gray or beige enamel finish Levels: 10V above sine wave
Cat A Ring: 6Kv, 200HZ, 35V above sin
Noise Filter Specifications Cat. B Ring: 6Kv, 500A, 60V above sine
Cat C Impulse: 6Kv, 1.2x5ms, 280v
Filter Modes: H – N, N – G, H – G Operating Temp: -40C to 80C
Cont. Duty Rating: 125V, 15A
Filter Range: 10-80dB (100KHz to 30MHz)
Unique Performance Specifications
Warranty: Suppressor Light: When lit, circuit is operating properly
Unconditional Lifetime Warranty
Fail Open Circuit: Dual thermal fuses
Models are available in 1 to 20 Outlets with shut off power to
Lengths up to 6 feet, and Rackmountable connected equipment
In the event of a
Suppression Component failure.
Dimensions and Weights: Complete Sine Clamps surges at the
Z6-6 (2P) 17”x2”x1-3/4” 2.7 lbs. Wave Clamping same safe levels
Z2-6 (2P) 12”x2”x1-3/4” 2.1 lbs. Regardless of where
Z3-6 (2P) 13-1/4”x2”x1-3/4” 2.3 lbs. The surge occurs
Z4-6 (2P) 14-1/4”x2”x1-3/4” 2.4 lbs. Along the wave